These are the Gen 2 Mod 3 non-rotating trigger/hammer pin sets for the POF GENERATION 3 & 4 RECEIVERS and MAY fit other receivers with ambidextrous bolt releases.

They are the toughest pins produced. We designed our pins to withstand the stresses generated by high-impact suppressed fire. Our trigger & hammer pins are stainless steel and our retainer sideplates are steel with a black nitride finish.

Our KNS non-rotating trigger/hammer pin sets prevent wear on your AR lower and prevent your pins from walking out of your receiver.

This kit includes an installation guide tool & 2 Torx wrenches. No permanent modification to your gun is required. These are the half-round style sideplates similar to our Gen 2 pin sets.

Torque spec for screw-tightening should not exceed 11 inch-lbs, 8 inch-lbs is recommended.